Tags: Calcium Hardness, Calcium Hardness Tests for Spas, Dirty spa filters, Foamy hot tub water, Foamy Spa, TDS, Total Dissolved Solids, Total Dissolved Solids (TDS)
Yikes! You turn your spa jets on, and suddenly your spa becomes a giant foam machine–or a latte gone wild. First, you scream at the kids asking who dumped soap into the spa. But you don’t have any kids and your spa doesn’t smell soapy.
1) Now ask yourself, how long ago did I drain my spa? Why? High Total Dissolved Solids (TDS) will cause foam. If your TDS reading (which you can have tested at your local spa shop) is over 1500 ppm, it’s time to dump the water, clean your spa, and start anew again.
2) Have you cleaned or replaced your spa’s filter in recent memory? If you draw a blank on this question, go directly to your spa’s filter, check it out and if it is anything but lilly white, it’s time to clean it. You can hose it off, but I recommend purchasing a filter cleaning solution from your local spa dealer, like Leisure Time Filter Clean.
Also if your filter has been servicing your spa for over 18 months, it may be time to replace it.
3) Calcium hardness is another cause of foam in your spa. If the calcium hardness is less than 200 ppm, bring it up with a calcium increase product, like Leisure Time’s Calcium Increase.
4) Have you diligently shocked your spa’s water? If not, the foam can easily be reduced with a good shock treatment using a non-chlorine shock, which you can find at your spa dealer. Shock your water, at the very least, once a week.
5) If you are missing a container of dish soap–well, it’s time to deal with the gremilins gone wild.
Tags: Calcium Chloride, Calcium Hardness, Calcium Hardness test for pools, Calcium Hardness Tests for Spas, Foamy hot tub water, Green Water, Swimming Pool
A proper test kit should contain a calcium hardness test mechanism. Calcium hardness tests were once just for swimming pools–but we’ve discovered that it is also important for your backyard hot tub. The reason to test for calcium hardness in pool water is because a low calcium hardness reading is destructive to the pool’s plaster. (Priced plaster replacement lately? Think second mortgage to pay for the replacement.)
All tap water has variable calcium hardness readings. In that same seam, low calcium hardness in a hot tub is not only corrosive, but also interferes with disinfection, and low calcium hardness can also cause your water to become foamy.
Spa and pool owners often think that they have a lot of minerals in their water and equate that to calcium hardness. WRONG. Calcium hardness is a different measurement apart from total hardness (and that also has little to do with TDS) .
So, the reason I wanted a calcium hardness reading on this sludgy spa was: 1) to determine the effectiveness of the disinfectant and; 2) to determine if this was adding to the ‘green sludge’ disaster–in that it could cause the water to foam.
Maintaining your spa’s water can be like maintaining your own skeletal health, but this low-calcium hardness business can destroy your spa or pool’s skeletal well-being. If your calcium hardness reading is below 250 ppms, then prepare for funky water, and a visit from your spa’s doctor for an expensive repair to the heater, pump seals and possibly more.
Raise calcium hardness with calcium chloride. You can pick this up at your local pool and spa store.